P.U. THINNER #205 is a slow drying thinner not interfering with urethane reaction performed by a wide range of evaporation. It is recommended to use in summer season when the temperature in the working place exceeds the room temperature.
Usg, 18L (Pail) and 200L (Drum)
Keep the container tightly closed. Shelf life is unlimited in close container. Keep away from direct sunlight and other sources of heat or ignition; do not smoke in storage areas.
P.U. THINNER #205 contains highly flammable solvents. Always use protective gloves and eye goggles when handling this product. It is highly recommended to provide proper ventilation on working area. If contact with skin or splash in eyes, wash with fresh water and seek medical advice.
• Quickly reduces the consistency of the lacquer to the required degree.
• Improves film smoothness of lacquers when applied either by spray or dipping thus extending excellent finish.
• Lacquer dries without blushing, resin blush, pin-holding and other surface defects.
• No “orange peel” developed after the evaporation of P.U. Thinner and therefore, increases the tensile strength of the film along with its gloss.
Appearance – Visual – Clear

Specific Gravity – ASTM D 1475 – 0.86 Kg/L

Colour (Say bolt) – ASTM D 1209 – +30

Boiling Point – ASTM D 850 – 100°C

Copper Corrosion – ASTM D 849 – none

Acidity – ASTM D 1613 – < 0.03%

Non-aromatics – 40%

Flash Points – IP 170 – 18°C

P.U. Thinner #205 is a mixture of aromatic hydrocarbon and selected esters. It is recommended for polyurethane varnishes due to its low evaporation.