Home » Wood Paints » Polyurethane Paints » PU texture
Pail-Mas-Paints

Polyurethane paints

PU texture

PU TEXTURE is a polyurethane material based on saturated polyester resin and special filler. It is formulated to give a maximum hardness and resistant to scratch, thanks for the high quality of raw material. Furthermore, PU TEXTURE is resistant to both extreme weather with no-yellowing effect, resistant to abrasion and provides a mild texture effect.
Request the TDS via
info@mas-paints.comor by filling out the form below.
Highly recommended to all woodworks, furniture such as beds, cabinets, chairs, sofas, doors and frames, turned pieces and the likes.

Appearance – Texture Finish

Colour – As per RAL/ NCS/ APS

Specific Gravity (20°C) – 1.25 +/- 0.2 kg/L

Viscosity (25°C, FC#4) – 40 – 60 sec.

Flash Point – 21°C

Mixing Dilution Ratio (FC#4, 13-15sec.)
Base – 100
Hardener – 50
Thinner – 25-30

Pot Life (20°C) – 5 – 6 hours

Shelf Life – 12 months

Drying Time (20°C)
Dust Free 15 – 17 min.
To Touch 45 – 60 min.
To Recoat 2 – 3 hours
Hard 24 – 36 hours

Non-Volatile (Wt.%) – 55 – 65

Gloss (60%) – Matt/ Satin

Application Condition
Air Temperature 5 – 35°C
Relative 85% max.

Application Method – Brush, Spray or Roller

Recommended Catalyst – Catalyst #013

Thinner – PU Thinner #105/ 205

Coverage – 6 – 8 m2/L

Base Coat – PU #153/Plastofil #350

The surface to be top coated should be primed with either polyurethane primer or polyester primer white.
It should be cleaned, well-sanded and free from dust, oil water and other contaminants to ensure no adverse effect will occur during application.
For cracks, crates and nail holes, it is advisable to fill with Putty Filler, NC Putty White #2185 or polyester Putty.
Apply 1 -2 coats of PU TEXTURE horizontally and vertically. It is not recommended to apply clear coat, but if it requires a protection, application of a thin of non-yellowing topcoat is acceptable.
One coat may be sufficient for ordinary finish however; one additional coat can be applied wet on wet if necessary. Light sanding with 400-600 grit sand paper is recommended before subsequent coats, when recoating time exceeds 3 hrs.

brush-product