PU matt (pigmented)

Appearance – Liquid Pigmented

Colour – RAL/NCS/APS

Specific Weight – 1.23 +/- 0.2 kg/L

Viscosity(FC#4 @25°C) – 60 – 75 sec.

Flash Point – 20°C

Non-Volatile (Wt.%) – 60 +/- 0.5

Gloss (600) – 10 /20 /30

Application condition:
Air temperature – 5 – 35°C
Relative Humidity – 85% max.

Application Method – Brush, Spray or Roller

Recommended Catalyst – Catalyst #013

Thinner – PU Thinner #105/205

Mixing/Dilution Ratio (Visc. 13-15” FC #4)
Base – 100
Cat. 50
Thinner 20-25

Pot life (25°C) – 2 – 3 hours

Drying time:
Dust free 15 – 17 min.
Touch free 45 – 60 min.
Recoat 2 – 3 hrs.
Hard 24 – 36 hrs.

Coverage – 6 – 8 m2/L

Hardness – 4H

Basecoat – PU 153 SP/Plastofil 350

The surface to be coated should be primed with PU or Polyester Primer.
It should be cleaned well-sanded and free from dust, oil, water and other contaminants.
To a well-prepared surface, apply 1 – 2 coats of PU MATT (PIGMENTED) horizontally and vertically.
PU MATT (PIGMENTED) when applied by curtain coater, the viscosity of the lacquer should be controlled and monitored for the continuity of the finish. Thinners should be added at pre-set periods to compensate the loss of solvent due to evaporation during application.
One coat may be sufficient for ordinary finish; however, one additional coat can be applied wet on wet if necessary. Light sanding with 400 – 600 grit sand paper is recommended before subsequent coats, when recoating time exceeds 3 hour.