Polyurethane paints
PU matt clear ny
PU MATT CLEAR NY is a polyurethane material based on polyfunctional saturated polyester resin. It is formulated to give a silky touch, thanks for the high quality of raw material. Furthermore, PU MATT CLEAR NY has a good film colour retention with no yellowing effect, resistant to abrasion and provides a very smooth finish.
Highly recommended to all woodworks, furniture such as beds, cabinets, chairs, sofas, doors and frames, turned pieces and the likes.
Appearance – Opalescent Liquid
Specific Gravity – 0.980 +/- 0.2 kg/L
Viscosity (25°C, FC #4) – 45 – 50 sec.
Flash Point – 20°C
Solid Content – 42%
Gloss (600) – 10 /20 / 30
Application Condition:
Air Temperature 5 -35°C
Relative Humidity 85% max.
Application Method – Conventional or Automatic Spraying
Recommended Catalyst – Catalyst #013
Thinner – PU Thinner #105/ 205
Mixing/Dilution Ratio (FC #4 = 13 – 15 sec.)
Base 100
Cat. 50
Thinner – 20-25
VOC – 270 g/L
Pot Life (25°C) – 5 – 6 hrs.
Drying Time (25°C)
Dust Free 20 – 25 mins.
To Touch 45 – 60 mins.
To Recoat 3 – 4 hrs.
Hard Dry 24 – 36 hrs.
Coating Rate – 7 – 8 m2/L (100 – 120 g/m2)
Surface to be top coated should be primed with either Polyurethane Primer or Polyester Primer White.
It should be cleaned, well-sanded and free from dust, oil water and other contaminants.
Apply 1 – 2 coats of PU MATT CLEAR NY, horizontally and vertically.
One or two coats may be sufficient for ordinary finish; however, additional coats can be applied wet to wet. If necessary, Light sanding with 600-800 grit sand paper is recommended before subsequent coats.
It should be cleaned, well-sanded and free from dust, oil water and other contaminants.
Apply 1 – 2 coats of PU MATT CLEAR NY, horizontally and vertically.
One or two coats may be sufficient for ordinary finish; however, additional coats can be applied wet to wet. If necessary, Light sanding with 600-800 grit sand paper is recommended before subsequent coats.
