PU matt clear c/10

Appearance – Transparent

Specific Gravity – 0.97 +/- 0.05 g/L

Viscosity @25°C – 40 – 50” FC#4

Flash Point – 20°C

Solid Content (Wt.%) – 45

Application Condition:
Air Temperature 5 – 35°C

Application Method – Auto or Conventional Spray

Recommended Catalyst – Catalyst #034

Thinner – PU Thinner #105/205

Mixing/Dilution Ratio (FC #4, 13-15 sec.)
Base 100
Cat. 50
Thinner 25-30
Pot Life – 3 – 4 hrs.

Drying Time:
Dust Free 15 – 20 min.
Touch Free 30 – 45 min.
Recoat 1 – 2 hrs.
Hard 24 – 36 hrs.

Coverage – 7 – 8 m2/L (120gms/m2)

Pencil Hardness – HB – H

Recoating
One coat may be sufficient for ordinary finish, However, one additional coat can be applied wet to wet of necessary. Light sanding with 400-600 mesh sand paper is recommended before subsequent coat when recoating time exceeds 3 hrs. and remove traces of wax.

The surface to be coated should be primed with basecoat lacquer clear either polyurethane or polyester based sealer.
It should be cleaned, well-sanded and free from dust, oil water and other contaminants.
To a well-prepared surface, apply 1-2 coats of PU MATT CLEAR C/10, horizontally and vertically.
To obtain a perfect finish coat, sand again with a very fine sand paper and repeat the coating process.