Polyurethane paints
PU matt as clear
PU MATT AS CLEAR is a premium polyurethane clear lacquer based on poly – functional saturated polyester resins and special additives, to provide smooth and satin finish with excellent resistance to mechanical and chemical stress. It has extremely surface hardness and good scratch resistance.
PU MATT AS CLEAR is excellent for wood furniture such as beds, table top, cabinets, chairs, sofas, doors, hand rails and frames.
Appearance – Opaque
Specific Weight – 1.0 kg/L
Viscosity @ 25°C – 35 – 40” FC #4
Flash Point – 20°C
Non-Volatile – 48 – 50%
Gloss – 20 / 30 /40
Application Condition:
Air Temperature 5 -35°C
Relative Humidity 85% max.
Application Method – Conventional or Automatic Spraying
Recommended Catalyst – Catalyst #023
Thinner – PU Thinner #105/ 205
Mixing Ratio (Wt.%)
Spray Visc. = 13 – 15”
Base 100
Cat. 50
Thinner 20-25
VOC – 270 g/L
Pot Life (25°C) – 2 – 3 hrs.
Drying Time (25°C)
Dust Free 15 – 20 mins.
To Touch 30 – 45 mins.
To Recoat 1 – 2 hrs.
Hard Dry 48 – 72 hrs.
Coating Rate – 8 – 10 m2/L (100 – 120 g/m2)
Pencil Hardness – 7 – 8 Newton (Erichsen)
Surface to be top coated must be primed with PU Sealer, Primeseal or Polyester Sealer.
It should be cleaned, well-sanded and free from dust, oil water and other contaminants.
To a well – prepared surface, apply 1 – 2 coat of PU MATT AS CLEAR, horizontally and vertically.
One or two coat may be sufficient for ordinary finish; however, to obtain a good finish, additional coat can be applied wet to wet if necessary. Light sanding with 400 – 600 grit sand paper is recommended before subsequent coat when recoating exceeds 3 hrs. and remove traces of wax.
Full hardness can be achieved after 3 days after the application.
It should be cleaned, well-sanded and free from dust, oil water and other contaminants.
To a well – prepared surface, apply 1 – 2 coat of PU MATT AS CLEAR, horizontally and vertically.
One or two coat may be sufficient for ordinary finish; however, to obtain a good finish, additional coat can be applied wet to wet if necessary. Light sanding with 400 – 600 grit sand paper is recommended before subsequent coat when recoating exceeds 3 hrs. and remove traces of wax.
Full hardness can be achieved after 3 days after the application.
