Polyurethane paints
Primeseal clear
PRIMESEAL CLEAR is a polyurethane sealer based on functional-saturated polyesters. A two component materials with excellent covering property, elasticity and sanding characteristics. Because of the good quality of raw materials, it does give a covering film of great transparency and requires minimum coat.
Request the TDS via
info@mas-paints.comor by filling out the form below.
info@mas-paints.comor by filling out the form below.
Best for furniture, office tables, shelves turned pieces, cabinets, doors and frames and all wood works.
Appearance – Clear
Specific Gravity (20°C) – 0.960 kg/L
Viscosity (25°C, FC#4) – 15 – 20 sec
Flash Point – 25°C
Non-Volatile (Wt%)
Base – 43+/-0.5
Hardener – 32+/-0.5
Application Condition
Air Temperature – 5 – 35°C
Relative Humidity – 85% max.
Application Method – Manual or Automatic
Recommended Catalyst – Catalyst 8031-6315
Thinner – Thinner 105/ 205
Mixing/Dilution (wt%)
Base – 100
Hardener – 50
Thinner – 15-20%
Pot Life (20°C) – 4 – 6 hours
Drying Time: (20°C)
Dust Free 10 – 15 minutes
To Touch – 20 – 35 minutes
To Recoat 2 – 3 hours
Hard – 24 – 36 hours
Sandable – 2 – 3 hours
Coverage – 8 – 10 m2/L (90-120gms/m2)
Recoating
Minimum 30min-max 3 hrs. medium sanding with 240/360 grit sand paper is recommended before subsequent coat is needed.
Prepare the surface to be painted with manual or automatic sanding machine.
Apply the required dye or stain (optional)
Apply 1 – 2 coats of PRIMESEAL with catalyst, vertically and horizontally.
After the primed coat gets dried, sand with medium sand paper up to the extent not to damage the substrate.
If required, apply wood putty transparent or putty fillers on nail holes, cracks and joints. Apply 1 -2 coats of PRIMESEAL prior to the final sanding and top coating.
To obtain a close grain finishes to a deep grain woods and veneers, apply multicoated PRIMESEAL with time intervals per coat to ensure no entrapment of micro bubbles that causes finishing defects.
Apply the required dye or stain (optional)
Apply 1 – 2 coats of PRIMESEAL with catalyst, vertically and horizontally.
After the primed coat gets dried, sand with medium sand paper up to the extent not to damage the substrate.
If required, apply wood putty transparent or putty fillers on nail holes, cracks and joints. Apply 1 -2 coats of PRIMESEAL prior to the final sanding and top coating.
To obtain a close grain finishes to a deep grain woods and veneers, apply multicoated PRIMESEAL with time intervals per coat to ensure no entrapment of micro bubbles that causes finishing defects.
