Water based wood paints
HYDROTUFF 5500
HYDROTUFF 5500 is mono component water – based polyurethane/acrylic dispersion for interior/exterior wood coating. It is developed to provide a hard resistant film with excellent abrasion and high flexibility and environment-friendly. HYDROTUFF 5500 meets the VOC content limit of Annex II, Phase II, Table A of European Directive 2004/42/EC:2004
- MAJOR USES
- ADVANTAGES
- CHARACTERISTICS & PHYSICAL PROPERTIES
- STORAGE
- PHYSIOLOGICAL HAZARDS
- APPLICATION PROCEDURE
It is best recommended for coating wooden surfaces, furniture, turn pieces, bamboo canes and the like. It has exceptional floor protection for light to moderate traffic. HYDROTUFF 5500 is available in matt to glossy finish which gives an excellent smoothness and opacity.
- Excellent hardness
- Flexible
- Non–toxic / Environment–friendly
- Fast Drying
Appearance: Clear
Specific Gravity: 1.00 kg/L
Viscosity: (25ºC, FC #4): 80-100 sec.
Gloss: 10/30/50/80
Application Condition:
Air Temperature 5~35ºC
Relative humidity Max. 85%
Application Method: Brush, Conventional or Automatic Spray
Drying Time:
Dust Free 20–30min
To Touch 45–60min.
To Recoat 2-3 hrs
Piling up 24–36hrs.
VOC: 122 g/L
Coating Rate: 8-10 m2/L (coverage will vary depending on the porosity of the surface)
Recoating: Two (2) coats may be sufficient for ordinary finish, Light sanding with 400~600 grit sandpaper is recommended before subsequent coat when recoating time exceeds 8 hours and remove traces of wax.
Store in the dark, cool and dry places. Shelf life up to 15 months in closed container.
See Safety Indication Sheet.
- The mixture is ready for use and can be applied by brush or spray. Surface to be coated must be free of dirt and other contaminants. In the remaking of old woods, it is imperative to remove traces of wax, dirt and other oily matter to ensure a perfect adhesion of paints
- First coat can be diluted with 5-10% with clean demineralised water and allow to dry for an hour before sanding to remove any raise grain.
- Ensure that HYDROTUFF 5500 is applied uniformly and never leave unsealed surface to avoid moisture.
