Home » Wood Paints » Water based wood paints » Hydroseal 5000
Pail-Mas-Paints

General & Speciality products

hydroseal 5000

HYDROSEAL 5000 is a self-cross-linking water-based sealer for interior/exterior wood coating. It is developed to provide a hard film but excellent sanding ability, high flexibility and environment friendly.
download datasheet
HYDROSEAL 5000 is mainly used as a basecoat for all types of water-based topcoat (PU/Acrylic). It is widely used as a sealer for all wood surfaces, thick woods, veneer, MDF, Bamboo canes and the like.
  • Excellent hardness.
  • Flexible.
  • Easy to sand.
  • Fast-drying.
  • Non-toxic/Environment-friendly.

Appearance – Clear

Specific gravity – 1.045

Viscosity (25ºC,FC #4) – 35 – 40 sec.

VOC – 125 g/L

Gloss – Matt

Diluent – Water

Application Condition – Air Temperature 5 – 35ºC, Relative Humidity Max. 85%

Application Method – Brush, Conventional or Automatic Spray

Drying Time (25ºC) – Dust-free 20 – 30 minutes, To touch 45 – 60 minutes, To recoat 2 – 3 hours, Piling 24 – 36 hours

Coating rate – 8-10 m2/L (Coverage will vary depending on porosity of surface).

Two (2) coats may be sufficient for the ordinary finish, allow two (2) hours drying between coats, a light sanding with 400 or 600 grit sand paper is recommended before subsequent coat when recoating time exceeds 8 hours and ensure to remove traces of wax.

  • The mixture is ready for use and can be applied by brush or spray.  The surface to be coated must be free of dirt and other contaminants.  In the remaking of old woods, it is imperative to remove traces of wax, dirt and other oily matter to ensure perfect adhesion of paints.
  • HYDROSEAL 5000 can be diluted with 5 – 10% with clean demineralized water, and allow to dry for an hour before sanding to remove any raised grain.
  • Ensure that HYDROSEAL 5000 is applied uniformly and never leave an unsealed surface to avoid moisture.

HYDROSEAL 5000 has a good resistance without additives.  It is resistant to chemical agent stabilize from Level 1-B DIN 68861 part 1.  To improve the chemical and hardness, add 0.5 – 1.0% of catalyst.

HYDROSEAL 5000 does not contain heavy metal and therefore, it can be used for toys in accordance with European Std’d EN 71-3 for Toy Security.

The drying room temperature should not be lower than 15ºC and the humidity must be less than 85ºC.  If the condition is beyond the required temperature, the possibility of slow drying smooth film and less chemical resistance.  It is recommended for a good dry by force drying without humidity starting from normal temperature up to 30ºC.

brush-product