EPOXY BASED PAINTS

uniseal #110

UNISEAL #110 is a two-component epoxy based material produced specifically to seal open pores of concrete, wood, bricks and the like. Seals up to 2 mm. depth to eliminate water seepage especially for vertical surfaces.

As a primer sealer prior to top coating

As a concrete conditioner

Reduces undercutting and peeling

Waterproofing and humidity protection

Abrasion and impact resistant

Temperature and chemical resistant

Provides durable sealer

Easy to apply

High Flexible

Excellent adhesion to minimal surface preparation

Colour – Clear

Volume solids – 42%

Components – Two (2)

Mixing ratio – 1 : 1 By volume

Touch Dry – 45 – 60 min.

Recoating Interval – 5 – 6 hrs.

Fully Cure – 7 days

Coverage – 12 /16 m2/L

NEW-STEEL:
New concrete should be cured at least 28 days. Remove all loose debris and other contaminants prior to application of multi-etch solution, rinse with fresh water and let it dry for 24 hrs.

OLD CONCRETE:
Concrete should be dry, free from dust, oil, debris and other contaminants. Remove all existing coat (if any) by scraping, grinding or with paint remover.

UNISEAL #110 can be applied by brush, roller and spray.  Mix thoroughly 1 part of Resin A and 1 part of Hardener B and let stand for 10 – 15 minutes prior to application.  Dilution of 5 – 10 % of Epoxy Thinner #135 is recommended if the consistency of the mixture is higher than the required application viscosity.  Use a roller suitable for solvent base to evenly distribute the materials.

brush-product