Acrylic based paints
Acrylic sealer clear uv/071
ACRYLIC SEALER CLEAR UV/071 are based on acrylic resin for non-yellowing basecoat. It is developed to provide a good covering, good sanding ability and preserves natural colour of the wood. Because of its extended UV absorption, it provides protection to coated light sensitive substrates.
Best recommended for furniture, tables, chair, doors and frames, outdoors furniture and external wood works.
Appearance – Opaque
Specific Gravity – 0.98 kg/L
Viscosity – 60”
Flash Point – 230C
Non-Volatile – 40%
Application Condition
Air Temperature 5 – 35C
Relative Humidity 85% max
Application Method – Brush, Airless, Conventional Spray
Recommended Catalyst – Catalyst #026
Thinner
PU Thinner #105/205
AR Thinner #305
Mixing/Dilution Ratio (% Volume)
Base 100
Hardener 20
Thinner 25/30
Pot Life 6 – 8 hours
Drying Time
Dust Free 20 – 30 min.
To Touch 35 – 45 min
To Recoat 2 – 3 hours
Hard 24 –36 hours
Coating Rate – 5-7 m2/L (90-120 gms/m2)
Recoating
Minimum 30 min-max 3 hrs. medium sanding with 240-360 mesh sand paper is recommended before subsequent coat is needed.
The mixture ready for use, can be applied by brush, roller or spray. Surface to be painted must be free of dirt and other contaminants. In the remaking of old woods, it is imperative to remove traces of wax, dirt and other oily matter to ensure a perfect adhesion of paint. Apply 1 – 2 coats of Acrylic Sealer Clear UV/071.
Mixing ration should be correctly observed.
Paint should be used within the pot life after components have been mixed together.
Pot life decreases at high temperature.
Bubbling due to excessive coatings within relatively short time is likely to occur in summer. 1-2 thin initial coat and longer recoating interval (50-60 min) eliminates bubbling.
Never leave drums of catalyst open.
Paint should be used within the pot life after components have been mixed together.
Pot life decreases at high temperature.
Bubbling due to excessive coatings within relatively short time is likely to occur in summer. 1-2 thin initial coat and longer recoating interval (50-60 min) eliminates bubbling.
Never leave drums of catalyst open.
