Acrylic based paints
Acrylic sealer clear ta/061
ACRYLIC SEALER CLEAR TA/061 is based on acrylic resin for non-yellowing basecoat. It is developed to provide a good covering, good sanding ability and preserves natural colour of the wood. It is weather resistant, unaffected by humidity, heat and sunlight.
Best recommended for furniture, tables, chairs, doors and frames, outdoors furniture and external wood works.
Appearance – Opaque
Specific Gravity(200C) – 0.980
Viscosity (250C, FC # 4) – 60 +/- 5 sec.
Flash Point – 230C
Non-Volatile (wt.%) – 40 +/- 0.5
Application Condition
Air Temperature 5
Relative Humidity 350C – 85% max.
Application Method – Brush, Spray, Roller
Recommended Catalyst – Catalyst #026
Thinner -PU Thinner #205/305
Mixing/Dilution Ratio (wt%)
Base 100
Hardener 20
Thinner 25/30
Pot Life (200C) – 6 – 8 hours
Drying Time (200C)
Dust Free 20 – 30 min.
To Touch 35 – 45 min
To Recoat 2 – 3 hrs.
Hard 24 – 36 hrs.
Coverage – 5-7 m2/L (90-120 gms/m2)
Recoating
Minimum 30 min-max 3 hrs. medium sanding with 240-360 mesh sand paper is recommended before subsequent coat is needed.
The mixture ready for use, can be applied by brush, roller or spray. Surface to be painted must be free of dirt and other contaminants. In the remaking of old woods, it is imperative to remove traces of wax, dirt and other oily matter to ensure a perfect adhesion of paint. Apply 1 – 2 coats of Acrylic Sealer Clear TA/061.
Mixing ration should be correctly observed.
Paint should be used within the pot life after components have been mixed together.
Pot life decreases at high temperature.
Bubbling due to excessive coatings within relatively short time is likely to occur in summer. 1-2 thin initial coat and longer recoating interval (50-60 min) eliminates bubbling.
Never leave drums of catalyst open.
Paint should be used within the pot life after components have been mixed together.
Pot life decreases at high temperature.
Bubbling due to excessive coatings within relatively short time is likely to occur in summer. 1-2 thin initial coat and longer recoating interval (50-60 min) eliminates bubbling.
Never leave drums of catalyst open.
